Lightning McQueen Plaque

This Lightning McQueen bedroom name plaque was a gift for my young grandson and was cut directly from an image I found on the net to which I added my Grandson's name.

I used PaintShopPro 7 to superimpose the lettering but any image editing software should allow you to do this. Simply right-click on the above image and select "save image as" to get it onto your hard drive then go over the outline of all the obvious body parts with a shapie and set to with a piece of 3mm ply to cut out the parts before sanding and painting them then gluing them onto a backer board. I used 3mm poster board as a backer so my daughter had the maximum choice of where Callum could attatch the plaque using double sided foam pads.